Brief introduction of dust self-cleaning cartridge dust collector:
Self cleaning cartridge dust collector Guohai filter uses rigid filter material to form a folded and uniform filter barrel, which makes it have smaller volume and larger filtration area effect. The outer layer of ordinary filter material is covered with a layer of superfine fiber, so that the filtering effect is improved essentially. The filtered dust only stays on the surface of the superfine fiber layer of the filter material, so the filtration resistance is greatly reduced, the power consumption is saved by more than 30%, the energy saving effect is remarkable, and the ash cleaning is very thorough. At the same time, it also solves all kinds of difficult problems such as superfine dust and fibrous dust. PTFE membrane filter material is suitable for wet dust containing gas. As the contact angle between filter material and water is greater than 108 degrees, the wet dust attached to the surface of filter material does not stick to the filter material and is easy to blow off. Therefore, the problem of moisture dust condensation and sticking is completely solved. Filtration efficiency: the collection capacity of dust with particle size of more than 5 μ m is 99.9% for ordinary filter media, and 99.9% for particle size above 0.5 μ m for membrane filter media. The normal service temperature of the common filter cartridge is 80 ℃ (130 ℃ if specified in the order).
Gh-clpa-3.0 cyclone ? Single pulse bag filter ? Filter cartridge dust collector of CNC cutting machine
Performance characteristics of self-cleaning cartridge dust collector
1. The advanced settling flow layout and inclined filter barrel structure are adopted, so the synchronous dust removal effect of the dust collector is good in the working process.
2. The purification efficiency is high, 99% for the dust above submicron. The purification efficiency is more than 9%, and the running resistance of the equipment is low, and the energy consumption of the dust removal system is effectively saved.
3. A dust baffle is set at the inlet of dust and gas, which has the function of buffering and abrasion resistance, so that the dust does not directly impact the filter cartridge at high speed, so the service life of the filter cartridge can be prolonged.
4. The 15 ° inclined drawer type installation of the filter cartridge can make it more convenient to remove and replace the filter cartridge. Moreover, there is no transmission part in the dust collector, which reduces the maintenance work. For general dust, the filter cartridge can be used for a long time without replacement, which saves the tedious work of frequent bag filter bag replacement, and saves a lot of maintenance costs.
5. Modular combination, size can be selected at will, can expand the original combination, add dust removal unit, and do not need to make too many changes to the original equipment.
Technical parameters of dust self-cleaning cartridge dust collector:
? ? Brand: Guohai
Filtration precision: 0.2, 0.5um, 1um, 5um, 10um, 20um, 30um, 100um, 200um
Initial resistance: 150pa
Back blowing pressure: 0.2-0.6mpa
Ash cleaning mode: manual dust cleaning / pulse automatic
Voltage (V) 220 / 380
Frequency (Hz) 50
Speed (R / min) 2840
Flow rate (m3 / h) 1900-2400
Wind pressure (PA) 1350-1240
Noise (< dB) 80
Application fields of dust self-cleaning cartridge dust collector:
1. For various types of air compressor stations in various industries, multiple compressors with small capacity can be used together, and one with large capacity can be used.
2. Raw material air compressor of oxygen station.
3. Blast furnace blowers in iron and steel works.
4. Gas turbines of various capacities.
5. A diesel engine that needs to run for a long time.
6. Air conditioning and air supply system of chemical fiber textile industry.
7. Central air conditioning system with high requirements for air dust content.
8. Chemical industry solution pollution and prevention. (matching use)